LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (F4A42) >> Automatic Transaxle System >> DTC U0001 Can Communication Malfunction >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Ignition "ON" & Engine "OFF".
  2. Disconnect the "PCM/TCM" connector.
  3. Measure resistance between terminal "77" and "78" of the "PCM/TCM" harness connector.

    Specification : approx. 120 ± 10Ω

    Fig 1: Measuring Resistance Between Terminal "77" And "78" Of PCM/TCM Harness Connector
    G05186434Courtesy of KIA MOTORS AMERICA, INC.
  4. Is measured resistance within specifications?

    YES 

    • Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage of ECM and then Repair or replace Resistance for CAN communication as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.