LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (F4A42) >> Automatic Transaxle System >> DTC P0755 Shift Control Solenoid Valve B Circuit Malfunction >> Component Inspection

Component Inspection

  1. CHECK SOLENOID VALVE
    1. Ignition "OFF".
    2. Disconnect "A/T SOLENOID VALVE" connector.
    3. Measure resistance between terminal "3" and terminal "5" of the ATM SOLENOID VALVE harness connector.

      Specification: Approximately 2.7~3.4 Ω [20°C (68°F)]

      Fig 1: Measuring Resistance Between Terminal "3" And Terminal "5" Of ATM Solenoid Valve Harness Connector
      G05186414Courtesy of KIA MOTORS AMERICA, INC.
    4. Is resistance within specification?

      YES 

      • Go to  2"CHECK PCM/TCM" as below.

      NO 

  2. CHECK PCM/TCM
    1. Connect scantool to data link connector (DLC).
    2. Ignition "ON" & Engine "OFF".
    3. Select ATM solenoid valve actuator test and operate actuator test.
    4. Can you hear operating sound for UD SOLENOID VALVE actuator testing function?

      YES 

      NO 

      ACTUATOR TEST CONDITION 

      1. IG SWITCH ON
      2. TRANSAXLE RANGE SWITCH is normal
      3. P RANGE
      4. Vehicle Speed 0mph (0km/h)
      5. Throttle position sensor < 1V
      6. IDLE SWITCH ON
      7. ENGINE RPM 0