LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (F4A42) >> Automatic Transaxle System >> DTC P0743 Torque Converter Clutch Circuit - Electrical >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. Connect scantool to data link connector (DLC).
  2. Engine "ON".
  3. Monitor the "TCC SOL. VALVE" parameter on the scantool
  4. Select "D RANGE" and Operate "TCC SOLENOID DUTY" more than 85%.
    Fig 1: Scantool Display - DCCSV Duty
    G05186387Courtesy of KIA MOTORS AMERICA, INC.
  5. Does "TCC SOLENOID DUTY" follow the reference data?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO