LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (F4A42) >> Automatic Transaxle System >> DTC P0703 Brake S/W Malfunction >> Component Inspection

Component Inspection

  1. Check "STOP LAMP SWITCH"
    1. Ignition "OFF" & Engine "OFF".
    2. Disconnect "STOP LAMP SWITCH" connector and Remove "STOP LAMP SWITCH".
    3. Measure resistance between terminal "1" and "2" of the STOP LAMP SWITCH when plunger of the STOP LAMP SWITCH is pushed in.

      Specification : Infinite

      Fig 1: Measuring Resistance Between Terminal "1" And "2" Of Stop Lamp Switch
      G05186334Courtesy of KIA MOTORS AMERICA, INC.
      Fig 2: Identifying Stop Lamp Switch Plunger Position
      G05186335Courtesy of KIA MOTORS AMERICA, INC.
    4. Is resistance within specifications?

      YES 

      • Go to  2"Adjust STOP LAMP SWITCH" as below.

      NO 

  2. Adjust "STOP LAMP SWITCH" Clearance
    1. Ignition "OFF" & Engine "OFF".
    2. Reinstall "STOP LAMP SWITCH".
    3. Adjust "STOP LAMP SWITCH" Clearance as below.

      Specification : 0.9mm (0.04in)

      Fig 3: Identifying Stop Lamp Switch Clearance
      G05186336Courtesy of KIA MOTORS AMERICA, INC.
    4. After Adjusting, has problem been solved?

      YES 

      NO 

      • Substitute with a known-good TCM/PCM and check for proper operation. If the problem is corrected, replace TCM/PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.