Electronic Throttle Control Adaptive Value Reset/Relearn - Mil With DTC P0638/P2110 (ENG078)
Publication date: 2010-11-01Reference number: ENG078
ELECTRONIC THROTTLE CONTROL ADAPTIVE VALUE RESET/RELEARN - MIL WITH DTC P0638/P2110
TECHNICAL SERVICE BULLETIN
| KIA: | 2007-2010 Rondo (UN); 2010-2011 Forte/Forte Koup (TD); 2006-2010 Optima (MG); 2011 Optima (TF); 2011 Sorento (XM); 2011 Sportage (SL) |
| GROUP: | Engine |
SERVICE INFORMATION
This bulletin provides the procedure to reset (erase) and relearn the Electronic Throttle Control (ETC) adaptive value (throttle valve position) on the following Kia vehicles: Rondo (UN), Forte/Forte Koup (TD), Optima (TF), Optima (MG), Sorento (XM), and Sportage (SL) with Theta-2.0/2.4L gasoline engines with ETC systems.
After the following repairs have been completed, the ETC adaptive value must be reset/relearned. If starting engine without resetting/relearning the ETC adaptive values; DTCs P0638 or P2110 will be stored in the ECM memory, and the MIL will be illuminated.
- ETC assembly or TPS (Throttle Position Sensor) replacement
- ECM replacement
- ECM software upgrade
Trouble Code Descriptions:
P0638: Throttle actuator control range/performance
P2110: Throttle actuator control system - Force limited RPM
If the MIL continues to be illuminated with DTC P0638 or P2110, even though the ETC adaptive value has been reset/relearned, follow appropriate Service Manual to diagnose and repair the ETC system or related components.
Reset/Relearn ETC Adaptive Value Service Procedure:
- Check for DTC(s) P0638/P2110.
- Clear DTC(s).
- Select Option/Data Treatment.
- Resetting adaptive values.
- Select "Reset"
, then wait 10 seconds after turning ignition key off (Relay OFF).
- Wait for 5 seconds after turning ignition ON (ETC adaptive value relearn).
- Start engine.
- Recheck DTC(s).CAUTION: If engine is started without waiting for at least 5 seconds after turning the ignition key to the ON position to allow the ECM to automatically learn the throttle valve position, MIL illumination with DTC P0638 and P2110 will occur. In this case, repeat the above procedure.
If equipped with PUSH BUTTON START SYSTEM, push the engine start button 2 times WITHOUT DEPRESSING THE BRAKE PEDAL, this will allow the ECM to automatically learn the throttle valve position; then wait for approximately 5 seconds.