Tightening Torque Table Of Standard Parts
TIGHTENING TORQUE SPECIFICATION
| Bolt nominal diameter (mm) | Pitch (mm) | Torque Nm (kg.cm, lb.ft) | |
|---|---|---|---|
| Head Mark 4 | Head Mark 7 | ||
| M5 | 0.8 | 3 ~ 4 (30 ~ 40, 2.2 ~ 2.9) | 5 ~ 6 (50 ~ 60, 3.6 ~ 4.3) |
| M6 | 1.0 | 5 ~ 6 (50 ~ 50, 3.6 ~ 4.3) | 9 ~ 11 (90 ~ 110, 6.5 ~ 8.0) |
| M8 | 1.25 | 12 ~ 15 (120 ~ 150, 9 ~ 11) | 20 ~ 25 (200 ~ 250, 14.5 ~ 18.0) |
| M10 | 1.25 | 25 ~ 30 (250 ~ 300, 18 ~ 22) | 30 ~ 50 (300 ~ 500, 22 ~ 36) |
| M12 | 1.25 | 35 ~ 45 (350 ~ 450, 25 ~ 33) | 60 ~ 80 (600 ~ 800, 43 ~ 58) |
| M14 | 1.5 | 75 ~ 85 (750 ~ 850, 54 ~ 61) | 120 ~ 140 (1,200 ~ 1,400, 85 ~ 100) |
| M16 | 1.5 | 110 ~ 130 (1,100 ~ 1,300, 80 ~ 94) | 180 ~ 210 (1,800 ~ 2,100, 130 ~ 150) |
| M18 | 1.5 | 160 ~ 180 (1,600 ~ 1,800, 116 ~ 130) | 260 ~ 300 (2,600 ~ 3,000, 190 ~ 215) |
| M20 | 1.5 | 220 ~ 250 (2,200 ~ 2,500, 160 ~ 180) | 360 ~ 420 (3,600 ~ 4,200, 260 ~ 300) |
| M22 | 1.5 | 290 ~ 330 (2,900 ~ 3,300, 210 ~ 240) | 480 ~ 550 (4,800 ~ 5,500, 350 ~ 400) |
| M24 | 1.5 | 360 ~ 420 (3,600 ~ 4,200, 260 ~ 300) | 610 ~ 700 (6,100 ~ 7,000, 440 ~ 505) |
NOTE:
- The torques shown in the table are standard values under the following conditions:
- Nuts and bolts are made of galvanized steel bar.
- Galvanized plain steel washers are inserted.
- All nuts, bolts and plain washers are dry.
- The torques shown in the table are not applicable
- When spring washers, toothed washers and the like are inserted.
- If plastic parts are fastened.
- If self-tapping screws or self-locking nuts are used.
- If threads and surfaces are coated with oil.
- Reduce the torque values to the indicated percentage of the standard value under the following conditions.
- If spring washers are used: 85%
- If threads and bearing surfaces are stained with oil: 85%