LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2005 >> Spectra5 2.0 1, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures - 2.0L >> Troubleshooting For DTC >> DTC P0420: Main Catalyst Efficiency Below THRESHHOLD Bank 1 >> Inspection Procedure

Inspection Procedure

  1. CHECK DTC RELEVANT TO HO2S/FUEL TRIM MISFIRE 
    1. Connect a Hi-Scan (Pro) to the data link connector.
    2. Turn the ignition switch ON and monitor any other DTCs relating to HO2S, fuel trim, or misfire.

    Are any other DTCs also set?

    1. No:  Go to next step.
    2. Yes: Do all repairs associated with those codes before proceeding with this procedure.
  2. MONITOR THE MANIFOLD CATALYTIC CONVERTER 
    1. Turn ignition switch to OFF position, and then reset the ECM with pulling the ECM fuse for about 10 seconds.
    2. Perform process 3 through 6 in this step to reset the readiness code.
    3. Start engine and hold the engine at 3,000 rpm with no load (in "Park" or "Neutral" position) until the radiator fan comes on.
    4. Drive for about 10 minutes without stopping on highway or freeway (Your speed can vary).
    5. In D-range for A/T or 5th gear for M/T, drive at steady speed between 50 and 62 mph (between 80 and 100 kph) for 30 seconds.
    6. Repeat Step 5 three times. Between each repetition, close the throttle completely for 1 or 2 seconds. If the engine is stopped during this part of the procedure, repeat process 4, 5 and 6 in this step.
    7. Check for a temporary DTC with the Hi-Scan (Pro).

    Does the scan tool indicate temporary DTC P0420?

    1. No:  Go to next step.
    2. Yes: Check the catalytic converter. If necessary, replace the catalytic converter.
  3. CHECK FOR READINESS CODE COMPLETION 

    If the readiness is complete, it was intermittent failure, and system is OK at this time.

    If the readiness code is incomplete, repeat process 3 through 6 in step  2.