LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2005 >> Spectra5 2.0 1, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures - 2.0L >> Troubleshooting For DTC >> DTC P0171: System Too Lean (Bank 1) >> Inspection Procedure

Inspection Procedure

  1. CHECK DTC RELATING TO INJECTOR, HO2S, ECTS, OR MAFS 
    1. Connect a Hi-Scan (Pro) to the data link connector.
    2. Turn ignition to ON position and monitor other DTCs.

      Are DTCs relating to injector, HO2S, ECTS, or MAFS also set?

    1. No:  Go to next step.
    2. Yes: Do all repairs associated with those codes before proceeding with this procedure.
  2. CHECK FUEL/SEALS/GASKETS FOR CONTAMINATION AND/OR LEAK 
    1. Visually/physically inspect the following items :
      • Throttle body gasket
      • Gasket between intake manifold and cylinder head
      • Seals between intake manifold and fuel injectors
      • Seals between surge tank and PCV valves
      • Crankcase ventilation valve and/or system for leaks
      • Contaminated fuel
      • Oil filler cap
      • Oil level gauge

    Are all items okay?

    1. Yes:  Go to next step.
    2. No: Repair or replace it.
  3. CHECK AIR CLEANER/MAFS/EXHAUST SYSTEM 

    Visually/physically inspect the following items :

    • Air cleaner element for being restricted.
    • Inspect Mass Air Flow Sensor (MAFS)
    • Check for exhaust gas leakage
    • Check for main relay circuit (Open or short circuit)

    Are all items okay?

    1. Yes:  Go to next step.
    2. No: Repair or replace it.
  4. CHECK CONNECTIONS 

    Check vacuum hoses for splits and proper connections. (Especially PCSV, throttle body, intake manifold, and brake booster).

    Are all connections okay?

    1. Yes:  Go to next step.
    2. No: Repair or replace it.
  5. CHECK VACUUM AT PCSV 
    1. Disconnect PCSV connector and EVAP hose (PCSV side) between PCSV and canister.
    2. Start engine and check vacuum at PCSV at idle.
      NOTE: In 40 seconds after starting the engine (the engine is already warmed up), PCSV operates. So this test must be terminated for 40 seconds.

      Is vacuum present?

      1. No:  Go to next step.
      2. Yes: PCSV or circuit failure. Repair according to DTC P0444  and DTC P0445  repair procedures.
  6. CHECK FUEL LINE PRESSURE 
    1. Reconnect the ignition coils and spark plug connectors.
    2. Release the fuel pressure and attach the fuel pressure gauge.
    3. Start the engine and warm it up to operating temperature.
    4. Check fuel line pressure at idle.

    Is fuel line pressure correct with ignition switch ON?

    1. Yes:  Go to next step.
    2. No: Check fuel delivery system.
  7. CHECK INJECTOR FOR NORMAL OPERATION 
    1. Start engine and check engine RPM decrease when disconnecting each injector connector in sequence.
    2. Measure the decreasing engine RPM of all cylinders.

    Is there any cylinder with no change in RPM or only a small change in RPM?

    1. No:  Go to next step.
    2. Yes: Repair or replace it.
  8. CHECK ECM INPUT SIGNALS 

    Check for ECM input signal from MAFS, HO2S, TPS and other input signals.

    Are input signals within specification?

    1. Yes:  Proceed with ECM PROBLEM INSPECTION PROCEDURE .
    2. No: Replace all failed parts.