Inspection Procedure
- CHECK DTC RELATING TO MAFS/TPS
- Connect a Hi-Scan (Pro) to the data link connector.
- Turn ignition switch to ON position and monitor other DTCs.
Is any DTC relating to MAFS or TPS set?
- No: Go to next step.
- Yes: Do all repairs associated with those codes before proceeding with this procedure.
- PROBLEM VERIFICATION
- Warm up engine to normal operating temperature.
- Using Hi-Scan (Pro), monitor MAFS signals while changing throttle position.
- Specification (MAFS signal voltage):
0.6 ~ 1.0 V at idle
1.7 ~ 2.0 V at 3000 rpm
- Specification (MAFS signal voltage):
Does signal change normally according to TPS signal?
- No: Go to next step.
- Yes: Problem is intermittent or was repaired and ECM memory was not cleared. See INTERMITTENT PROBLEM INSPECTION PROCEDURE ..
- CHECK TPS RESISTANCE
- Turn ignition switch to OFF and disconnect TPS connector.
- Measure resistance between the terminals 1 and 2 of TPS connector.
- Specification (TPS resistance) 0.71 ~ 1.38 kΩ at idle position 0.2 ~ 3.4 kΩ at W.O.T
- Measure resistance between the terminals 2 and 3 of TPS connector.
- Specification (TPS resistance): 1.6 ~ 2.4 kΩ at all throttle position
Is resistance within specification?
- Yes: Go to next step.
- No: Replace TPS.
- CHECK MAFS, TPS, AND ECM CONNECTORS
Thoroughly check connectors for loose, poor connection, bent, corrosion, contamination, deterioration, or damage. See CONNECTOR INSPECTION PROCEDURE .
Are all connectors good?
- Yes: Go to next step.
- No: Repair or replace it.
- CHECK AIR CLEANER
Check air cleaner for dirt, blockage, or damage.
Is air cleaner good?
- Yes: Go to next step.
- No: Clean or replace it.
- CHECK INTAKE SYSTEM FOR LEAKAGE
Check entire air intake system for leaks or blockages such as:
- Throttle body
- PCV valve
- Intake manifold
- Gasket between intake manifold and surge tank
- Seals between intake manifold and fuel injectors
- Seal between surge tank and PCV pipe
Is entire air intake system good?
- Yes: Go to next step.
- No: Repair or replace it.
- CHECK MAFS SIGNAL AGAIN
- Reconnect the ECM and MAFS connectors.
- Connect a Hi-Scan (Pro) to the data link connector.
- Start the engine and monitor the MAFS signals.
- Specification (MAFS signal voltage):
0.6 ~ 1.0 V at idle
1.7 ~ 2.0 V at 3000 rpm
Is signal within specification?
- Yes: Proceed with ECM PROBLEM INSPECTION PROCEDURE
- No: Replace MAFS.
- Specification (MAFS signal voltage):