Inspection Procedure
- CHECK KNOCK SENSOR AND ECM CONNECTORS
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. See CONNECTOR INSPECTION PROCEDURE .
Are all connectors good?
- Yes: Go to next step.
- No: Repair or replace it.
- CHECK FOR OPEN IN HARNESS
- Turn ignition switch to OFF position, and then disconnect KS and ECM connector.
- Measure resistance between terminal 2 of the KS harness connector and 54 of the ECM harness connector.
- Measure resistance between terminal 1 of the KS harness connector and 10 of the ECM harness connector.
Specification (Resistance): below 1Ω
Does each resistance indicate continuity?
- Yes: Go to next step.
- No: Repair open in harness.
- CHECK FOR SHORT TO GROUND IN HARNESS
- Turn ignition switch to OFF position, and then disconnect KS and ECM connector.
- Measure resistance between terminal 1 of the KS harness connector and chassis ground.
- Measure resistance between terminal 1 and 2 of the KS harness connector.
Specification (Resistance): infinite
Does each resistance indicate open?
- Yes: Go to next step.
- No: Repair short or short to chassis ground in harness.
- CHECK FOR SHORT TO POWER IN HARNESS
- Turn ignition switch to OFF position, and then disconnect KS and ECM connectors.
- Turn ignition switch to ON position.
- Measure voltage between terminal 1 of the KS harness connector and chassis ground.
Specification (Voltage): below 0.5V
Is voltage within specification?
- Yes: Go to next step.
- No: Repair short to power in harness.
- CHECK KNOCK SENSOR SIGNAL
- Reconnect the ECM and KS connectors.
- Connect a Hi-Scan (Pro) to the knock sensor.
- Start the engine and monitor the KS signal at idle. See SIGNAL WAVE FORM .
Is KS signal normal?
- Yes: Go to next step.
- No: Replace KS.
- CHECK KNOCK SENSOR
- Turn ignition switch to OFF position and disconnect KS connectors.
- Measure capacitance between terminal 1 and 2 of the KS connector.
Specification (capacitance): 0.8 ~ 1.6 nF (800 ~ 1,600 pF)
Is the measured capacitance within specification?
- Yes: Proceed with ECM PROBLEM INSPECTION PROCEDURE .
- No: Replace KS.