LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2005 >> Spectra LX, 2.0 2, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures - 2.0L >> Troubleshooting For DTC >> DTC P0011: Camshaft Position Timing Over Advanced Or System Performance >> Inspection Procedure

Inspection Procedure

  1. PROBLEM VERIFICATION
    1. Connect a Hi-Scan (Pro) to the data link connector.
    2. Clear DTC(s) and freeze frame data.
      NOTE: Don't delete DTC(s) and freeze frame data before making out the "CUSTOMER PROBLEM ANALYSES SHEET", see CUSTOMER PROBLEM ANALYSIS SHEET .
    3. Start the engine and wait until cooling fan comes on.
    4. Race the engine to 2,000 through 3,000 rpm with no load 5 times.
    5. Check DTC(s) using Hi-Scan (Pro).

    Is DTC P001 indicated?

    1. Yes:  Go to next step.
    2. No: Problem is intermittent or was repaired and ECM memory was not cleared, see INTERMITTENT PROBLEM INSPECTION PROCEDURE .
  2. VISUALLY CHECK OCV
    1. Turn ignition to OFF position.
    2. Remove the OCV from the engine.
    3. Visually check the Spool Column of OCV for contamination.

    Is the Spool Column of OCV normal?

    1. Yes:  Go to next step.
    2. No: Repair or replace the OCV.
  3. CHECK OCV RESISTANCE
    1. Turn ignition switch to OFF position and disconnect OCV connector.
    2. Measure resistance between terminals 1 and 2 of the OCV connector.
      1. Specification (OCV resistance):
      Fig 1: OCV Resistance Specifications
      G00719318Courtesy of KIA MOTORS AMERICA, INC.
      Fig 2: Checking OCV Resistance
      G00719319Courtesy of KIA MOTORS AMERICA, INC.

      Is resistance within specification?

      1. Yes:  Go to next step.
      2. No: Replace OCV.
    3. CHECK THE SUSPECTED AREA

      Check the following items:

      • OCV filter for sticking or contamination
      • Engine oil and it's level
      • Engine oil filter

      Is there any problem?

      1. No:  Go to next step.
      2. Yes: Repair or replace it.
    4. CHECK OCV
      1. Install a well-known good OCV.
      2. Connect a Hi-Scan (Pro) to the data link connector.
      3. Clear DTC(s) and freeze frame data.
      4. Start the engine and wait until cooling fan comes on.
      5. Race the engine to 2,000 through 3,000 rpm with no load 5 times and wait for 10 seconds.
      6. Check DTC(s) using Hi-Scan (Pro).

      Is DTC P0011 indicated?

      1. Yes:  Proceed with ECM PROBLEM INSPECTION PROCEDURE .
      2. No: Replace OCV.