LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2004 >> Spectra LX, 2.0 2, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures - 2.0L >> Troubleshooting For DTC >> DTC P0445: EVAP Emission Control System Purge Valve Circuit Shorted >> Inspection Procedure

Inspection Procedure

  1. CHECK PCSV AND ECM CONNECTORS 

    Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. See CONNECTOR INSPECTION PROCEDURE .

    Are all connectors good?

    1. Yes:  Go to next step.
    2. No: Repair or replace it.
  2. CHECK PCSV RESISTANCE 
    1. Turn ignition switch to OFF and disconnect PCSV connector.
    2. Measure resistance between the terminal 1 and 2 of PCSV connector.

      Specification (PCSV resistance):

      Fig 1: PCSV Resistance Specification Chart
      G00719449Courtesy of KIA MOTORS AMERICA, INC.
      Fig 2: Checking PCSV Resistance
      G00719450Courtesy of KIA MOTORS AMERICA, INC.

    Is resistance within specification?

    1. Yes:  Go to next step.
    2. No: Replace PCSV.
  3. CHECK POWER TO PCSV 
    1. Turn ignition switch to OFF position and disconnect PCSV connector.
    2. Turn ignition switch to ON position.
    3. Measure voltage between terminal 1 of the PCSV harness connector and chassis ground.

      Specification (Voltage): approximately B+

      Fig 3: Checking Power To PCSV
      G00719451Courtesy of KIA MOTORS AMERICA, INC.

    Is voltage within specification?

    1. Yes:  Go to next step.
    2. No: Repair open or short to chassis ground in harness.
  4. CHECK FOR SHORT TO GROUND IN HARNESS 
    1. Turn ignition switch to OFF position, and then disconnect PCSV and ECM connectors.
    2. Measure resistance between terminal 2 of the PCSV harness connector and chassis ground.

      Specification (Resistance): infinite

      Fig 4: Check For Short To Ground In Harness
      G00719452Courtesy of KIA MOTORS AMERICA, INC.

    Does the resistance indicate open?

    1. Yes:  Go to next step.
    2. No: Repair short or short to chassis ground in harness.
  5. CHECK FOR SHORT TO POWER IN HARNESS 
    1. Turn ignition switch to OFF position, and then disconnect PCSV and ECM connectors.
    2. Turn ignition switch to ON position.
    3. Measure voltage between terminal 2 of the PCSV harness connector and chassis ground.

      Specification (Voltage): below 0.5V

      Fig 5: Checking For Short To Power In Harness
      G00719453Courtesy of KIA MOTORS AMERICA, INC.

    Is voltage within specification?

    1. Yes:  Proceed with ECM PROBLEM INSPECTION PROCEDURE .
    2. No: Repair short to power in harness.