Inspection Procedure
- CHECK DTC RELEVANT TO HO2S/FUEL TRIM MISFIRE
- Connect a Hi-Scan (Pro) to the data link connector.
- Turn the ignition switch ON and monitor any other DTCs relating to HO2S, fuel trim, or misfire.
Are any other DTCs also set?
- No: Go to next step.
- Yes: Do all repairs associated with those codes before proceeding with this procedure.
- MONITOR THE MANIFOLD CATALYTIC CONVERTER
- Turn ignition switch to OFF position, and then reset the ECM with pulling the ECM fuse for about 10 seconds.
- Perform process 3 through 6 in this step to reset the readiness code.
- Start engine and hold the engine at 3,000 rpm with no load (in "Park" or "Neutral" position) until the radiator fan comes on.
- Drive for about 10 minutes without stopping on highway or freeway (Your speed can vary).
- In D-range for A/T or 5th gear for M/T, drive at steady speed between 50 and 62 mph (between 80 and 100 kph) for 30 seconds.
- Repeat Step 5 three times. Between each repetition, close the throttle completely for 1 or 2 seconds. If the engine is stopped during this part of the procedure, repeat process 4, 5 and 6 in this step.
- Check for a temporary DTC with the Hi-Scan (Pro).
Does the scan tool indicate temporary DTC P0420?
- No: Go to next step.
- Yes: Check the catalytic converter. If necessary, replace the catalytic converter.
- CHECK FOR READINESS CODE COMPLETION
If the readiness is complete, it was intermittent failure, and system is OK at this time.
If the readiness code is incomplete, repeat process 3 through 6 in step 2.