LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2004 >> Spectra LX, 2.0 2, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures - 2.0L >> Troubleshooting For DTC >> DTC P0325: Knock Sensor Circuit Malfunction >> Inspection Procedure

Inspection Procedure

  1. CHECK KNOCK SENSOR AND ECM CONNECTORS 

    Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. See CONNECTOR INSPECTION PROCEDURE .

    Are all connectors good?

    1. Yes:  Go to next step.
    2. No: Repair or replace it.
  2. CHECK FOR OPEN IN HARNESS 
    1. Turn ignition switch to OFF position, and then disconnect KS and ECM connector.
    2. Measure resistance between terminal 2 of the KS harness connector and 54 of the ECM harness connector.
    3. Measure resistance between terminal 1 of the KS harness connector and 10 of the ECM harness connector.

      Specification (Resistance): below 1Ω

      Fig 1: Checking For Open In Harness
      G01820688Courtesy of KIA MOTORS AMERICA, INC.

    Does each resistance indicate continuity?

    1. Yes:  Go to next step.
    2. No: Repair open in harness.
  3. CHECK FOR SHORT TO GROUND IN HARNESS 
    1. Turn ignition switch to OFF position, and then disconnect KS and ECM connector.
    2. Measure resistance between terminal 1 of the KS harness connector and chassis ground.
    3. Measure resistance between terminal 1 and 2 of the KS harness connector.

      Specification (Resistance): infinite

      Fig 2: Checking For Short to Ground In Harness
      G01820689Courtesy of KIA MOTORS AMERICA, INC.

    Does each resistance indicate open?

    1. Yes:  Go to next step.
    2. No: Repair short or short to chassis ground in harness.
  4. CHECK FOR SHORT TO POWER IN HARNESS 
    1. Turn ignition switch to OFF position, and then disconnect KS and ECM connectors.
    2. Turn ignition switch to ON position.
    3. Measure voltage between terminal 1 of the KS harness connector and chassis ground.

      Specification (Voltage): below 0.5V

      Fig 3: Checking For Short To Power In Harness
      G01820690Courtesy of KIA MOTORS AMERICA, INC.

    Is voltage within specification?

    1. Yes:  Go to next step.
    2. No: Repair short to power in harness.
  5. CHECK KNOCK SENSOR SIGNAL 
    1. Reconnect the ECM and KS connectors.
    2. Connect a Hi-Scan (Pro) to the knock sensor.
    3. Start the engine and monitor the KS signal at idle. See SIGNAL WAVE FORM .

    Is KS signal normal?

    1. Yes:  Go to next step.
    2. No: Replace KS.
  6. CHECK KNOCK SENSOR 
    1. Turn ignition switch to OFF position and disconnect KS connectors.
    2. Measure capacitance between terminal 1 and 2 of the KS connector.

      Specification (capacitance): 0.8 ~ 1.6 nF (800 ~ 1,600 pF)

      Fig 4: Checking Knock Sensor
      G01820691Courtesy of KIA MOTORS AMERICA, INC.

    Is the measured capacitance within specification?

    1. Yes:  Proceed with ECM PROBLEM INSPECTION PROCEDURE .
    2. No: Replace KS.