LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2004 >> Spectra LX, 2.0 2, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures - 2.0L >> Troubleshooting For DTC >> DTC P0101: Mass Air Flow Circuit Range/Performance >> Inspection Procedure

Inspection Procedure

  1. CHECK DTC RELATING TO MAFS/TPS
    1. Connect a Hi-Scan (Pro) to the data link connector.
    2. Turn ignition switch to ON position and monitor other DTCs.

    Is any DTC relating to MAFS or TPS set?

    1. No:  Go to next step.
    2. Yes: Do all repairs associated with those codes before proceeding with this procedure.
  2. PROBLEM VERIFICATION
    1. Warm up engine to normal operating temperature.
    2. Using Hi-Scan (Pro), monitor MAFS signals while changing throttle position.
      1. Specification (MAFS signal voltage):

        0.6 ~ 1.0 V at idle

        1.7 ~ 2.0 V at 3000 rpm

    Does signal change normally according to TPS signal?

    1. No:  Go to next step.
    2. Yes: Problem is intermittent or was repaired and ECM memory was not cleared. See INTERMITTENT PROBLEM INSPECTION PROCEDURE ..
  3. CHECK TPS RESISTANCE
    1. Turn ignition switch to OFF and disconnect TPS connector.
    2. Measure resistance between the terminals 1 and 2 of TPS connector.
      • Specification (TPS resistance) 0.71 ~ 1.38 kΩ at idle position 0.2 ~ 3.4 kΩ at W.O.T
    3. Measure resistance between the terminals 2 and 3 of TPS connector.
      • Specification (TPS resistance): 1.6 ~ 2.4 kΩ at all throttle position
      Fig 1: Checking TPS Resistance
      G00719398Courtesy of KIA MOTORS AMERICA, INC.

    Is resistance within specification?

    1. Yes:  Go to next step.
    2. No: Replace TPS.
  4. CHECK MAFS, TPS, AND ECM CONNECTORS

    Thoroughly check connectors for loose, poor connection, bent, corrosion, contamination, deterioration, or damage. See CONNECTOR INSPECTION PROCEDURE .

    Are all connectors good?

    1. Yes:  Go to next step.
    2. No: Repair or replace it.
  5. CHECK AIR CLEANER

    Check air cleaner for dirt, blockage, or damage.

    Is air cleaner good?

    1. Yes:  Go to next step.
    2. No: Clean or replace it.
  6. CHECK INTAKE SYSTEM FOR LEAKAGE

    Check entire air intake system for leaks or blockages such as:

    • Throttle body
    • PCV valve
    • Intake manifold
    • Gasket between intake manifold and surge tank
    • Seals between intake manifold and fuel injectors
    • Seal between surge tank and PCV pipe

    Is entire air intake system good?

    1. Yes:  Go to next step.
    2. No: Repair or replace it.
  7. CHECK MAFS SIGNAL AGAIN
    1. Reconnect the ECM and MAFS connectors.
    2. Connect a Hi-Scan (Pro) to the data link connector.
    3. Start the engine and monitor the MAFS signals.
      1. Specification (MAFS signal voltage):

        0.6 ~ 1.0 V at idle

        1.7 ~ 2.0 V at 3000 rpm

      Is signal within specification?

      1. Yes:  Proceed with ECM PROBLEM INSPECTION PROCEDURE
      2. No: Replace MAFS.