Inspection Procedure
- PROBLEM VERIFICATION
- Connect a Hi-Scan (Pro) to the data link connector.
- Clear DTC(s) and freeze frame data.NOTE: Don't delete DTC(s) and freeze frame data before making out the "CUSTOMER PROBLEM ANALYSES SHEET", see CUSTOMER PROBLEM ANALYSIS SHEET .
- Start the engine and wait until cooling fan comes on.
- Race the engine to 2,000 through 3,000 rpm with no load 5 times.
- Check DTC(s) using Hi-Scan (Pro).
Is DTC P001 indicated?
- Yes: Go to next step.
- No: Problem is intermittent or was repaired and ECM memory was not cleared, see INTERMITTENT PROBLEM INSPECTION PROCEDURE .
- VISUALLY CHECK OCV
- Turn ignition to OFF position.
- Remove the OCV from the engine.
- Visually check the Spool Column of OCV for contamination.
Is the Spool Column of OCV normal?
- Yes: Go to next step.
- No: Repair or replace the OCV.
- CHECK OCV RESISTANCE
- Turn ignition switch to OFF position and disconnect OCV connector.
- Measure resistance between terminals 1 and 2 of the OCV connector.
- Specification (OCV resistance):
Is resistance within specification?
- Yes: Go to next step.
- No: Replace OCV.
- CHECK THE SUSPECTED AREA
Check the following items:
- OCV filter for sticking or contamination
- Engine oil and it's level
- Engine oil filter
Is there any problem?
- No: Go to next step.
- Yes: Repair or replace it.
- CHECK OCV
- Install a well-known good OCV.
- Connect a Hi-Scan (Pro) to the data link connector.
- Clear DTC(s) and freeze frame data.
- Start the engine and wait until cooling fan comes on.
- Race the engine to 2,000 through 3,000 rpm with no load 5 times and wait for 10 seconds.
- Check DTC(s) using Hi-Scan (Pro).
Is DTC P0011 indicated?
- Yes: Proceed with ECM PROBLEM INSPECTION PROCEDURE .
- No: Replace OCV.