LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2024 >> Gladiator Nighthawk, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Outlet, Power >> Removal And Installation >> Switch - Cargo 115 Volt

Switch - Cargo 115 Volt

REMOVAL 

NOTE:

The Cargo Power Outlet is controlled by a bezel mounted switch that is located on the face of the instrument panel below the headlamp switch.

  1. Disconnect and isolate the negative battery cable(s). Refer to: BATTERY DISCONNECT - DUAL 12 VOLT BATTERY SYSTEM .
  2. Remove the driver side instrument panel cover, Refer to COVER, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
  3. Disconnect the wire harness connector from the 115 volt power switch.
    GC0192800Courtesy of CHRYSLER GROUP, LLC
    1 - Retaining Tab
    2 - Wire Harness Connector
    3 - Instrument Panel
    4 - Power Switch
  4. Using a trim stick C-4755 or equivalent tool, disengage the four retaining tabs and remove the 115 volt power switch from the driver side instrument panel.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle.