LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2022 >> Grand Cherokee Altitude, RWD >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Center, Power Distribution (PDC) >> Removal And Installation >> Left Quarter PDC >> Notes

Left Quarter PDC: Notes

REMOVAL 

  1. Disconnect and isolate the negative battery cable(s). Refer to 3.6L, BATTERY DISCONNECT AND CONNECT or 5.7L, BATTERY DISCONNECT AND CONNECT .
    GC0203348Courtesy of CHRYSLER GROUP, LLC
    1 - Access Cover
  2. Using a trim stick or equivalent, remove the left quarter trim panel access cover.
    GC0203197Courtesy of CHRYSLER GROUP, LLC
    1 - Retaining Tabs
    2 - Power Distribution Center (PDC)
    3 - Electrical Terminal Nut
    4 - Positive Cable
  3. Remove the electrical terminal nut and positive cable from the PDC.
  4. Release the retaining tabs securing the PDC to the PDC bracket.
    GC0203120Courtesy of CHRYSLER GROUP, LLC
    1 - Wire Harness Connectors
    2 - Power Distribution Center (PDC)
  5. Pull the PDC out from the PDC bracket and disconnect the wire harness connectors. Remove the PDC from the vehicle.
  6. If necessary, remove the fasteners from the PDC bracket and remove it from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

During installation, torque the fasteners to the specifications in the torque table(s) below.

TORQUE SPECIFICATIONS