LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2022 >> Gladiator Mojave, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Center, Power Distribution (PDC) >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Position the four PDC wire harness connectors onto the PDC.
  2. Secure the four wire harness connectors to the PDC by tightening the four bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  3. Secure the PDC to the lower tray by engaging all four latches on to the lock tabs.
  4. Install the Z-case fuse array eyelets on the PDC and tighten the nuts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  5. Install the PDC cover onto the PDC assembly until the latches fully engage the lock tabs.
  6. Connect the negative battery cable(s). Refer to 3.0L, BATTERY DISCONNECT & CONNECT - DUAL 12 VOLT BATTERY SYSTEM or 3.6L, BATTERY DISCONNECT & CONNECT - DUAL 12 VOLT BATTERY SYSTEM .