LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Cherokee High Altitude, Full Time T/Case Control >> Repair and Diagnosis >> Engine Performance >> 2.0L Ignition System (Service Information) >> Sensor, Camshaft Position >> Removal >> Intake (#2) Camshaft Position Sensor

Intake (#2) Camshaft Position Sensor

The Camshaft Position (CMP) sensors are located at the rear of the cylinder head and are bolted to the cylinder head.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the top and side engine covers. Refer to COVER, ENGINE, REMOVAL .
  3. Remove the air outlet pipe from turbocharger to throttle body. Refer to COOLER AND HOSES, CHARGE AIR, REMOVAL .
    GC0186467Courtesy of CHRYSLER GROUP, LLC
  4. Unlock and disconnect the CMP sensor wire harness connector (1).
    GC0186888Courtesy of CHRYSLER GROUP, LLC
  5. Remove the bolt (2) and the CMP sensor (1) from the cylinder head.