LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Gladiator Altitude, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Converter, Catalytic >> Removal And Installation >> Right Side

Right Side

REMOVAL 

  1. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECTION .
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the exhaust Y-pipe. Refer to Y-PIPE, EXHAUST, REMOVAL AND INSTALLATION .
  4. Remove the support and partially lower the vehicle.
  5. Remove the right tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  6. Remove the right side wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION , and SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION .
    GC0192761Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the up stream oxygen sensors wire harness connector (1).
  8. Detach the oxygen sensor wire harness from the retainers (2).
    GC0192941Courtesy of CHRYSLER GROUP, LLC
  9. Disconnect the down stream oxygen sensors wire harness connector (3).
    GC0192828Courtesy of CHRYSLER GROUP, LLC
  10. Saturate the bolts (1) with Mopar® Rust Penetrant lubricant. Allow 5 minutes for penetration.
  11. Remove the upper catalytic converter flange bolts (1).
  12. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0192845Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    The catalytic converter flange is secured to the cylinder head. A steel sleeve holds the lower section of the converter flange to the head while two bolts fasten the flange to the cylinder head. The steel sleeve does not need to be removed for converter removal.

  13. Using care, lift the catalytic converter (1) upwards to remove from the steel sleeve and out from the bottom of the vehicle.

INSTALLATION 

GC0192845Courtesy of CHRYSLER GROUP, LLC
  1. Using a NEW  gasket, position the catalytic converter assembly (1) into the steel sleeve on the cylinder head through the bottom of the vehicle.
  2. Remove the support and partially lower the vehicle.
    GC0192828Courtesy of CHRYSLER GROUP, LLC
  3. Install the upper catalytic converter bolts (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS - 3.6L .
    GC0192941Courtesy of CHRYSLER GROUP, LLC
  4. Connect the down stream oxygen sensor wire harness connector (1).
    GC0192761Courtesy of CHRYSLER GROUP, LLC
  5. Attach the oxygen sensor wire harness to the retainers (2).
  6. Connect the up stream oxygen sensor wire harness connector (1).
  7. Install the exhaust Y-pipe. Refer to Y-PIPE, EXHAUST, REMOVAL AND INSTALLATION .
  8. Install the right side wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION , and SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION .
  9. Install the right tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  10. Remove the support and lower the vehicle.
  11. Connect the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECTION .
  12. Start the vehicle and inspect for exhaust leaks. Repair exhaust leaks as necessary.