LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Compass Sport, Eng CD ED6, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Electronic Control Modules (Service Information) - Mp) >> Module, Emergency Assistance (EAM) >> Description And Operation >> Description And Operation >> Notes

Description And Operation: Notes

WARNING: This page is about a different car, the 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

DESCRIPTION 

In vehicles manufactured for certain export markets, an emergency crash notification system is included in the vehicle to automatically initiate an audio emergency call (eCall) to a Public Safety Answering Point (PSAP). An eCall can be manually triggered by the vehicle occupant if so desired. When triggered, whether automatically or manually, the vehicle eCall system will also attempt to send a Minimum Set of Data (MSD) to a public Mobile Network Operator (MNO) concerning the vehicle location and Vehicle Identification Number (VIN).

GC0178983Courtesy of CHRYSLER GROUP, LLC

The emergency crash notification system consists of the following components:

COMPONENT INDEX 

1. OCCUPANT RESTRAINT CONTROLLER (ORC)
2. ECALL SPEAKER
3. EMERGENCY ASSISTANCE MODULE (EAM)
4. RADIO RECEIVER MODULE (RRM)
5. REARVIEW MIRROR WITH MICROPHONES AND CALL BUTTONS
6. BODY CONTROL MODULE (BCM)

OPERATION 

The EAM system will detect an eCall trigger, whether automatic through a crash severe enough or manual at a vehicle occupant's request by pressing the SOS button. Once triggered, the system will attempt to send an MSD to any public system operated by an MNO and also attempt to establish a voice connection between the vehicle and the PSAP. When connected to the MNO, the vehicle will transfer the vehicle location and VIN.

The EAM system is triggered automatically when the ORC sends a signal using the Controller Area Network - Chassis (CAN-C) data bus or the Output Digital Serial line. The severity of the crash will determine if an eCall is sent or not. This will include direction of the impact, whether frontal, side, rear or rollover.

The EAM system can be manually triggered using the SOS button by the vehicle driver or a passenger. The EAM will actuate the system in the same manner as if it had been triggered automatically by the ORC. When eCall is in operation, the RRM audio will be muted and eCall audio will be heard through the eCall speaker.

In the event that the vehicle battery connection is compromised, a backup battery is mounted within the EAM to ensure the integrity of the system and a continuation of an eCall if the vehicle battery becomes disconnected while a call is in progress. If the backup battery becomes discharged, a message will be indicated in the Instrument Panel Cluster (IPC) and a diagnostic code set in the EAM.

The EAM microcontroller continuously monitors all of the EAM system electrical circuits to determine the system readiness. If the EAM detects a monitored system fault, it sets an active and stored Diagnostic Trouble Code (DTC) and sends electronic messages to the IPC and BCM over the CAN data bus to turn ON the EAM indicator. An active fault only remains for the duration of the fault, or in some cases for the duration of the current ignition cycle, while a stored fault causes a DTC to be stored in memory by the EAM.

The hard wired inputs and outputs for the EAM may be diagnosed using conventional diagnostic tools and procedures. Refer to the appropriate wiring information. However, conventional diagnostic methods will not prove conclusive in the diagnosis of the EAM or the electronic controls and communication between other modules and devices that provide some features of the EAM system. The most reliable, efficient and accurate means to diagnose the EAM or the electronic controls and communication related to EAM system operation requires the use of a diagnostic scan. Refer to the appropriate diagnostic information.