LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Delivery, Diesel >> Solenoid, Fuel Quantity >> Installation

Solenoid, Fuel Quantity: Installation

GC0145379Courtesy of CHRYSLER GROUP, LLC
  1. Install a NEW  gasket (2) and O-ring seal (1) onto the fuel quantity solenoid (3) and lubricate the O-ring seal (1) with clean diesel fuel.
    NOTE:

    Do not allow dirt or other contaminates to enter into the fuel injection pump.

  2. Remove the protective cap(s) from fuel injection pump.
    GC0145378Courtesy of CHRYSLER GROUP, LLC
  3. Install the fuel quantity solenoid (2) into the fuel injection pump and tighten the fasteners (3) to 7 N.m (62 in. lbs.).
  4. Connect the fuel quantity solenoid wire harness connector (1).
    GC0145422Courtesy of CHRYSLER GROUP, LLC
  5. Install the fuel injection pump blocker plate (7). Tighten the nuts (8) to 25 N.m (18 ft. lbs.).
  6. Install the charge air inlet hose.
  7. Connect the negative battery cable.
  8. Start engine and inspect for leaks.