LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2010 >> Grand Cherokee SRT-8 >> Repair and Diagnosis >> Transmission >> Transfer Case >> Final Drive Control Module (FDCM) - Electrical Diagnostics >> DTC Troubleshooting >> DTC C230A: Neutral Indicator Control Circuit Low >> Diagnostic Test

Diagnostic Test

  1. DTC IS ACTIVE 
    1. Ignition on, engine not running.
    2. With the scan tool, read DTCs.

      Is the status Active for this DTC?

      Yes 

      • Go to step  2

      No 

      • Go to step  6
  2. (G95) 4WD NEUTRAL INDICATOR CIRCUIT RESISTANCE TO GROUND 
    Fig 1: Measuring Resistance Between Ground & 4WD Neutral Indicator circuit
    GC0120066Courtesy of CHRYSLER LLC
    1. Turn the ignition off to the lock position
    2. Disconnect the FDCM C2 connector.
    3. Measure the resistance between ground and the (G95) 4WD Neutral Indicator circuit in the FDCM C2 harness connector.

      Is the resistance below 5.0 ohms?

      Yes 

      • Go to step  3

      No 

      • Go to step  4
  3. (G95) 4WD NEUTRAL INDICATOR CIRCUIT SHORT TO GROUND 
    Fig 2: Measuring Resistance Between Ground & 4WD Neutral Indicator Circuit
    GC0120066Courtesy of CHRYSLER LLC
    1. Disconnect the Transfer Case Selector Switch harness connector.
    2. Measure the resistance between ground and the (G95) 4WD Neutral Indicator circuit in the FDCM C2 harness connector.

      Is the resistance below 5.0 ohms?

      Yes 

      No 

  4. (G95) 4WD NEUTRAL INDICATOR CIRCUIT OPEN 
    Fig 3: Measuring Resistance Of 4WD Neutral Indicator Circuit
    GC0120067Courtesy of CHRYSLER LLC
    1. Disconnect the Transfer Case Selector Switch harness connector.
    2. Measure the resistance of the (G95) 4WD Neutral Indicator circuit between the Transfer Case Motor harness connector and the Final Drive Control Module C2 harness connector.

      Is the resistance above 5.0 ohms?

      Yes 

      No 

      • Go to step  5
  5. (F943) FUSED IGNITION SWITCH OUTPUT (RUN/START) VOLTAGE 
    Fig 4: Measuring Voltage Of Fused Ignition Switch Output (RUN/START) Circuit
    GC0120068Courtesy of CHRYSLER LLC
    1. Ignition on, engine not running.
    2. Measure the voltage of the (F943) Fused Ignition Switch Output (RUN/START) circuit in the Transfer Case Selector Switch harness connector.

      Is the voltage above 10.6 volts?

      Yes 

      No 

  6. INTERMITTENT WIRING AND CONNECTORS 
    1. The conditions necessary to set this DTC are not present at this time.
    2. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
    3. While monitoring the scan tool data relative to this circuit, wiggle test the wiring and connectors.
    4. Look for the data to change or for the DTC to reset during the wiggle test.

      Were any problems found?

      Yes 

      No 

      • Test complete.