LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2010 >> Grand Cherokee SRT-8 >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Fuel Injection, Gas >> Throttle Body >> Installation >> 5.7L

Throttle Body: Installation: 5.7L

Fig 1: Throttle Body O-Ring At Front Of Intake Manifold
GC0080447Courtesy of CHRYSLER LLC
  1. Clean and check condition of throttle body-to-intake manifold o-ring (2).
  2. Clean mating surfaces of throttle body and intake manifold.
  3. Install throttle body to intake manifold by positioning throttle body to manifold alignment pins.
  4. Install all throttle body mounting bolts finger tight.
    Fig 2: Throttle Body Mandatory Torque Tightening Sequence
    GC0080450Courtesy of CHRYSLER LLC
    CAUTION: The throttle body mounting bolts MUST be tightened to specifications. Over tightening can cause damage to the throttle body or the intake manifold.
  5. Obtain a torque wrench. Tighten mounting bolts (as shown in the illustration) in a mandatory torque criss-cross pattern sequence to 5.6 N.m (50 in. lbs.).
    Fig 3: Throttle Body - 5.7L
    GC0080446Courtesy of CHRYSLER LLC
  6. Install electrical connector (3).
  7. Install air plenum to flange (1).
  8. Connect negative battery cable.
  9. Using the diagnostic scan tool, perform the ETC Relearn function.