LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2010 >> Grand Cherokee SRT-8 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System (Service Information) >> Generator >> Removal >> 3.7L

Charging System (Service Information): Generator: Removal: 3.7L

Fig 1: Identifying Accessory Drive Belt 3.7L/4.7L
GC0085466Courtesy of CHRYSLER LLC
WARNING: Disconnect the negative cable from the battery before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage to the electrical system.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the serpentine belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal .
    Fig 2: Locating Generator & Connectors - 3.7L/4.7L
    GC0082800Courtesy of CHRYSLER LLC
  3. Unsnap the plastic insulator cap (3) from the B+ output terminal.
  4. Remove the B+ terminal mounting nut (2) at the rear of the generator. Disconnect the terminal from the generator.
  5. Disconnect the field wire connector (4) at rear of the generator by pushing on the connector tab.
    Fig 3: Removing/Installing Generator - 3.7L/4.7L
    GC0082801Courtesy of CHRYSLER LLC
  6. Remove one rear vertical generator mounting bolt (2).
  7. Remove two front horizontal generator mounting bolts (1).
  8. Remove the generator from the vehicle.