LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Liberty 4WD V6-3.7L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transfer Case >> Gear Sensor/Switch >> Service and Repair >> Installation

Installation







INSTALLATION





1. Install a NEW o-ring seal onto the encoder.




NOTE: Before installing the encoder onto the transfer case, be certain to align the encoder shaft to the shift shaft and the dowel on the encoder to the hole in the case accordingly.

2. Install the encoder onto the rear transfer case housing.
3. Install the encoder screws. Tighten the screws to 5-8 Nm (44-71 in.lbs.).
4. Install the electrical wiring harness connector onto the encoder.