LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Liberty 4WD V6-3.7L >> Repair and Diagnosis >> Starting and Charging >> Starting System >> Starter Relay >> Service and Repair >> Removal

Removal







REMOVAL





The fuel pump relay is located in the Power Distribution Center (PDC) (1). The PDC is located in the engine compartment near the left inner fender (2). Refer to label on PDC cover for relay location.

1. Remove PDC cover.
2. Remove relay from PDC.
3. Check condition of relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing relay.
4. Check for pin height (pin height should be the same for all terminals within the PDC connector). Repair if necessary before installing relay.