LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Liberty 4WD V6-3.7L >> Repair and Diagnosis >> Starting and Charging >> Starting System >> Ignition Switch >> Ignition Switch Lock Cylinder >> Service and Repair >> Key Cylinder >> Removal

Removal







REMOVAL





The ignition key (1) must be in the key cylinder (2) for cylinder removal. The key cylinder must be removed first before removing ignition switch.

1. If equipped with an automatic transmission, place shifter in PARK position.
2. Remove the shroud covers.
3. Remove the remote keyless entry (S.K.R.E.E.M) module.
4. Remove the halo ring around the cylinder.
5. Rotate key to ON position.
6. A release pin is located on the bottom of the key cylinder (5) with the access hole on the top of the lock cylinder housing (3).
7. Position a small screwdriver or pin punch (4) into pin access hole (5).
8. Push the pin punch (5) up while pulling key cylinder (2) from lock cylinder housing (3).