LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Liberty 4WD V6-3.7L >> Repair and Diagnosis >> Heating and Air Conditioning >> Refrigerant Pressure Sensor / Switch >> Service and Repair >> Removal

Removal







REMOVAL

NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.





NOTE: LHD model shown. RHD model similar.

1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2) located on the A/C liquid line (3) near the dash panel (4) in the engine compartment.
3. Remove the A/C pressure transducer from the A/C liquid line and remove and discard the O-ring seal.