LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Liberty 4WD V6-3.7L >> Repair and Diagnosis >> Heating and Air Conditioning >> Blower Motor Resistor >> Service and Repair >> Installation

Installation







INSTALLATION





NOTE: Typical resistor shown. RHD model similar.

1. Position the blower motor resistor (1) into the HVAC housing (4).
2. Install the two screws (3) that secure the blower motor resistor to the HVAC housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Connect the wire harness connector (2) to the blower motor resistor.
4. Close the glove box door.
5. Reconnect the negative battery cable.