LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Wrangler Unlimited, Standard >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition Control >> Camshaft Position Sensor >> Removal >> 4.0L >> Oil Pump Drive And CMP Sensor - 4.0L

Oil Pump Drive And CMP Sensor - 4.0L

If the CMP and oil pump drive are to be removed and installed, do not allow engine crankshaft or camshaft to rotate. CMP sensor relationship will be lost. 

Fig 1: 4.0L CMP Location
GC0030873Courtesy of DAIMLERCHRYSLER CORP.
1 - OIL PUMP DRIVE ASSEMBLY
2 - CMP
3 - CMP ELECTRICAL CONNECTOR
4 - HOUSING HOLD DOWN BOLT
5 - HOUSING
6 - PLASTIC COVER
7 - COVER SCREWS (2)
  1. Remove two plastic cover screws (7) and remove plastic cover (6). See Fig 1.
    Fig 2: 4.0L CMP Removal/Installation
    GC0030877Courtesy of DAIMLERCHRYSLER CORP.
    1 - OIL PUMP DRIVE HOUSING
    2 - CMP SENSOR
    3 - SENSOR MOUNTING BOLT
    4 - TARGET WHEEL
    5 - HOUSING
  2. Note and mark rotational position of target wheel (4) in relationship to housing (5). See Fig 2.
  3. Disconnect CMP electrical jumper harness (3) at engine wiring harness. See Fig 1.
  4. Before proceeding to next step, mark and note rotational position of oil pump drive housing (5) in relationship to engine block. After installation, the CMP sensor should face the 4 o'clock position as viewed from right side of engine. See Fig 1.
  5. Remove hold-down bolt (4) and clamp. See Fig 1.
  6. Pull assembly from engine.
  7. Remove and discard old oil pump drive-to-engine block gasket.