LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Wrangler Unlimited, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Servo >> Removal

Cruise Control Systems: Servo: Removal

  1. Disconnect negative battery cable at battery.
  2. Disconnect vacuum line at servo. See Fig 1.
  3. Disconnect electrical connector at servo.
  4. Disconnect servo cable at throttle body. Refer to CABLE  for Removal/Installation.
  5. Remove three bracket mounting bolts. See Fig 1.
  6. Remove 2 mounting nuts holding servo cable sleeve to bracket. See Fig 2.
  7. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip. Note: The servo mounting bracket displayed in. See Fig 2.Fig 2 is a typical bracket and may/may not be applicable to this model vehicle.
  8. Remove servo from mounting bracket. While removing, note orientation of servo to bracket.
Fig 1: Speed Control Servo Location
GC0030530Courtesy of DAIMLERCHRYSLER CORP.
1 - BRAKE POWER BOOSTER
2 - VACUUM LINE
3 - SERVO
4 - BRACKET BOLTS (3)
5 - SERVO MOUNTING BRACKET
Fig 2: Locating Servo Cable Clip - Typical
GC0030529Courtesy of DAIMLERCHRYSLER CORP.
1 - SERVO MOUNTING NUTS (2)
2 - SERVO
3 - CABLE RETAINING CLIP
4 - SERVO CABLE AND SLEEVE