LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Starter Motor >> Removal >> 2.4L

Starter Motor: Removal: 2.4L

  1. Disconnect and isolate negative battery cable.
  2. Raise and support vehicle.
  3. While supporting starter motor, remove two bolts securing starter motor to transmission. See Fig 1.
  4. Lower starter motor far enough to access and remove nut securing battery cable to starter solenoid B(+) terminal stud. See Fig 2. Always support starter motor during this process. Do not let starter motor hang from wire harness.
  5. Remove battery cable at starter.
  6. Disconnect solenoid terminal wire harness connector from starter solenoid.
  7. Remove starter motor.
Fig 1: Starter - 2.4L
GC0026386Courtesy of DAIMLERCHRYSLER CORP.
1 - STARTER
2 - MOUNTING BOLTS (2)
Fig 2: Starter Electrical Connectors - 2.4L/3.7L
GC0026388Courtesy of DAIMLERCHRYSLER CORP.
1 - BATTERY CABLE NUT
2 - BATTERY CABLE
3 - SOLENOID CONNECTOR
4 - HEAT SHIELD (IF USED)