LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2003 >> Wrangler L4-2.4L VIN P >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Acceleration/Deceleration Sensor >> Service and Repair

Acceleration/Deceleration Sensor: Service and Repair

G-SWITCH

REMOVAL
1. From the drivers side lift carpet back in front of the console/shifter.
2. Disconnect harness for switch.





3. Remove mounting bolts and remove switch.

INSTALLATION





CAUTION: The mercury switch (inside the G-switch), will not function properly if the switch is installed incorrectly. Verify that the switch locating arrow is pointing to the front of the vehicle.

1. Position switch on mounting bracket.
2. Install mounting bolts and tighten to 4 - 5 Nm (35 - 45 in. lbs.)
3. Connect harness to switch.
4. Place carpet back into position.