Test Ch-1A: Charging System No Code Test
NOTE:
Ensure battery is fully charged before proceeding and perform the following:
- DTC TEST .
- TEST TC-5A .
- TEST TC-6A .
- Inspect generator belt for proper tension and good condition. If generator belt is okay, go to next step. If generator belt tension is incorrect or belt is damaged, repair as necessary. Perform TEST VER-3A .
- Start engine. Turn on all accessories. Using scan tool, set engine speed at 2000 RPM for 30 seconds. Using scan tool, return engine speed to idle and read Diagnostic Trouble Codes (DTCs). If any DTCs pertaining to charging system exist, go to appropriate test. See SCAN TOOL DTC MESSAGES table under DTC TEST: CHECKING SYSTEM FOR DIAGNOSTIC TROUBLE CODES. If other DTC messages exist, see TESTS W/CODES article in the ENGINE PERFORMANCE Section. If no DTCs exist, go to next step.
- Turn ignition off. Turn ignition on with engine off. Using scan tool, actuate generator field. Using scan tool in voltmeter mode, backprobe Dark Green wire at 2-wire connector on rear of generator. Voltage should cycle from zero volts to battery voltage every 1.4 seconds.
- While monitoring voltage display on scan tool, wiggle wiring from 2-pin connector on rear of generator to Powertrain Control Module (PCM). On TJ bodies, PCM is located in right rear of engine compartment. On XJ body, PCM is located on left front fender in engine compartment.
- On all models, if no interruption of normal voltage cycle exists when wiggling wiring, go to next step. If interruption of normal voltage cycle exists when wiggling wiring, repair wiring as necessary. Perform TEST VER-3A .
- Using scan tool, read DTCs. If any DTCs exist pertaining to charging system, go to appropriate test. See SCAN TOOL DTC MESSAGES table under DTC TEST: CHECKING SYSTEM OF DIAGNOSTIC TROUBLE CODES. If other DTC messages exist, see TESTS W/CODES article in the ENGINE PERFORMANCE Section. If no DTCs exist, go to next step.
- Using external voltmeter, connect voltmeter positive lead on B+ (battery) terminal on rear of generator. Connect voltmeter negative lead to positive battery terminal.
- Start engine and note voltage reading on voltmeter. If voltage is 0.4 volt or less, go to next step. If voltage is more than 0.4 volt, repair B+ circuit between battery and generator for high resistance. Perform TEST VER-3A .
- Turn ignition off. Using external voltmeter, connect voltmeter positive lead on generator case. Connect voltmeter negative lead to negative battery terminal.
- Start engine and note voltage reading on voltmeter. If voltage is 0.1 volt or less, go to next step. If voltage is more than 0.1 volt, repair generator ground circuit from generator case to negative battery terminal for high resistance. Perform TEST VER-3A .
- Remove external voltmeter. Using scan tool, read and record battery voltage reading. Using external voltmeter, read and record battery voltage between positive and negative battery terminals.
- Compare both voltage readings obtained in step 11). If difference between both voltage readings is less than one volt, test is complete. Perform TEST VER-3A . If difference between both voltage readings is one volt or more, go to next step.
- Turn ignition off. Disconnect PCM connectors. Using external voltmeter, check voltage between ground and terminal No. 22 at PCM Black connector. See Figure. Compare voltage reading to voltage reading obtained using scan tool in step 11).
- If voltage reading is not within one volt of voltage reading obtained using scan tool in step 11), replace PCM. Perform TEST VER-3A . If voltage reading is within one volt of voltage reading obtained using scan tool in step 11), repair high resistance between PCM Black connector terminal No. 22 and battery. Perform TEST VER-3A .