LEMON Manuals: Even more car manuals for everyone

Chime Test 5A - Chime Inoperative With Exterior Lights On

NOTE: Perform CHIME TEST 1A  before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . After each repair, perform TEST VER-1A  .
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
  1. Before proceeding with this test, ensure park lights and headlights are operating properly. If park lights and headlights do not operate properly, go to EXTERIOR LIGHTING TEST 1A  . If park lights and headlights operate properly, go to next step.
  2. Open driver's door. Using scan tool, select CHIME MONITOR. Read door ajar switch status. If scan tool does not display LF DOOR AJAR SWITCH: CLOSED, go to DOOR AJAR TEST 3A  . If scan tool displays LF DOOR AJAR SWITCH: CLOSED, go to next step.
  3. Remove ignition key. Using scan tool, select CHIME MONITOR. Read key-in ignition switch status. If scan tool does not display KEY-IN IGNITION SW: OPEN, go to CHIME TEST 4B  . If scan tool displays KEY-IN IGNITION SW: OPEN, turn park lights on.
  4. Using scan tool, select CHIME MONITOR. Read park light switch status. If scan tool does not display PARK LAMP: ON, go to EXTERIOR LIGHTING TEST 1A  . If scan tool displays PARK LAMP: ON, turn headlights on. If chime does not sound, replace Body Control Module (BCM). BCM is located under left side of dash. See Figure in CHIME TEST 3A. If chime sounds, chime system is currently operating correctly.