Door Ajar Test 3A - Left Front Door Ajar Open Circuit
NOTE:
Perform DOOR AJAR TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. After each repair, perform TEST VER-1A
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
- Disconnect left front door ajar switch. Ensure left front door ajar switch ground strap is clean and not damaged. Repair or replace ground strap as required. If ground strap is okay, go to next step.
- Connect jumper wire between left front door ajar switch connector (Tan wire) and ground. Using scan tool, read left front door ajar switch status. If scan tool displays LF DOOR AJAR SWITCH: CLOSED, replace left front door ajar switch. If scan tool does not display LF DOOR AJAR SWITCH: CLOSED, disconnect jumper wire. Go to next step.
- Backprobe a jumper wire between terminal No. 4 (Tan wire) on BCM Black 14-pin connector and ground. Do not disconnect BCM connector. BCM is located under left side of dash. See Figure in CHIME TEST 3A. Using scan tool, read left front door ajar switch status. If scan tool displays LF DOOR AJAR SWITCH: CLOSED, repair open in Tan wire between left front door ajar switch and BCM. If scan tool does not display LF DOOR AJAR SWITCH: CLOSED, replace BCM.