Test SC-3A - Checking Cruise Control Set Switch
NOTE:
For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAM
.
- Set DRB in voltmeter mode. Turn ignition and cruise control on. Backprobe Brown/Red wire at cruise control SET switch connector. While observing voltage display, press SET switch. If voltage is greater than 10 volts, go to next step. If voltage is less than 10 volts, replace cruise control switch. Perform TEST SC-VER .
- Turn ignition off. Unplug Powertrain Control Module (PCM) connector. Inspect connector. Clean and repair as necessary. Perform TEST SC-VER . Turn ignition on. Using DRB in voltmeter mode, probe PCM connector terminal No. 48 (Brown/Red wire). Depress SET switch. If voltage is less than 10 volts when SET switch is depressed, go to next step. If voltage is greater than 10 volts when SET switch is depressed, replace PCM. Perform TEST SC-VER .
- If voltage is less than 10 volts when SET switch is depressed, repair open in Brown/Red wire between PCM connector and cruise control switch connector. Perform TEST SC-VER .