LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1982 >> Scrambler Base, 4.2L Eng VIN C, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Tune-Up - 6 CYL >> Ignition Timing

Ignition Timing

NOTE: Engines are equipped with a receptacle for a magnetic probe timing light, located 10° ATDC. Do not use this location to check timing with a conventional light.
  1. Connect timing light using inductive pickup or adaptor. Do not puncture spark plug wire. Connect tachometer, then disconnect and plug vacuum hose at distributor.
  2. Disconnect 2-wire (yellow and black) connector at electronic ignition module. Short circuit module terminal connectors with jumper wire (except on Federal CJ and Scrambler models). Start engine and adjust idle speed to specifications.
  3. Increase engine speed to 1600 RPM and adjust timing (except Federal CJ and Scrambler models). Set timing by loosening distributor clamp bolt and turning distributor. Recheck timing after clamp bolt is tightened.
TIMING SPECIFICATIONS (Degrees BTDC@RPM)

Application Man. Trans. Auto.Trans.
CJ & Scrambler
  Models
    Federal 8@650 8@550
Calif. 15@650 15@550
All Other Models
  High Altitude 19@1600 21@1600
Fed. & Calif. 15@1600 15@1600