LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2004 >> XK8 2D Convertible >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission/Transaxle External Controls >> Automatic Transmission/Transaxle External Controls >> External Controls - Diagnostic Procedures >> Pinpoint Tests >> Pinpoint Test : CHECK FOR POWER AND GROUND SUPPLIES TO THE LINEAR SWITCH MODULE

Pinpoint Test : CHECK FOR POWER AND GROUND SUPPLIES TO THE LINEAR SWITCH MODULE

  1. CHECK IGNITION SUPPLY VOLTAGE 

    Disconnect the linear switch module electrical connector, FC100.

    Turn the ignition switch to the ON position.

    Measure the voltage between FC100, pin 04 (WR) and GROUND.

    Is the voltage less than 10 volts? 

    YES:  REPAIR the circuit between the linear switch module and battery. This circuit includes the driver's side fuse box, (fuse 16) the ignition positive relay, and the high power protection module. For additional information, refer to the wiring diagrams. CLEAR the DTC. TEST the system for normal operation.

    NO:  Go to step  2.

  2. CHECK GROUND CIRCUIT 

    Turn the ignition switch to the OFF position.

    Measure the resistance between FC100, pin 11 (B) and GROUND.

    Is the resistance greater than 5 ohms? 

    YES:  REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC. TEST the system for normal operation.

    NO:  Check for DTCs. Carry out tests indicated by the DTCs logged.