Installation Procedure
- Install the linear shift assembly onto the steering column support assembly.
- Secure the linear shift assembly to the steering column support assembly with the 3 oval head tapping screws.
Move the linear shift assembly out of the PARK position to install the lower oval head tapping screw.
Tighten: Tighten the 3 TORX® screws to 10 N.m (89 lb in).
- Install the automatic transmission shift lock control.
Connect the automatic transmission shift lock control connector.
- Connect the park lock cable assembly (1) to the ignition lock cylinder case in the following way:
- Place the steering column lock cylinder set into the OFF position.
- Place the shift lever tube into the park position.
- Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.
- Install the shift lever. Refer to Shift Lever Replacement .
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.