LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2006 >> i-280 S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Control System & Fuel System - 2.9L - DTC P0013 To DTC P0315) >> DTC P0191 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Verify that the fuel tank is not empty. Only perform this diagnostic if there is at least 2 gallons of fuel in the fuel tank.
  1. Ignition OFF, disconnect the harness connector at the fuel line pressure sensor.
  2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the fuel pump flow control module.
  3. Ignition ON, test for 4.8-5.2 volts between the fuel line pressure sensor 5-volt reference circuit terminal 3 and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the fuel pump flow control module.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the fuel pump flow control module.
  4. Ignition OFF, install a 3A fused jumper wire between the 5-volt reference circuit terminal 3 and the signal circuit terminal 1.
  5. Ignition ON, observe the Fuel Pump Control Module Fuel Rail Pressure Sensor parameter. The scan tool should display between 4.8-5.2 volts.
    • If less than the specified range, test the signal circuit terminal 1 for a short to ground or an open/high resistance. If the circuit tests normal, replace the fuel pump flow control module.
  6. If all circuits test normal, replace the fuel rail pressure sensor.