Test Description
The number below refers to the step number on the diagnostic table.
- 2: If the voltage is varying above and below the specified range, the condition is not present.
DTC P0131
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Powertrain Control Module (PCM) Connector End Views or Engine Controls Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
300-600 mV | Go to Step 3 | Go to Step 4 |
| 3 |
|
- | Go to Step 4 | Go to Intermittent Conditions |
| 4 |
|
200 mV | Go to Step 6 | Go to Step 5 |
| 5 |
|
100 mV | Go to Step 7 | Go to Step 8 |
| 6 | Test the HO2S 1 high signal circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 15 | Go to Step 9 |
| 7 | Test the HO2S 1 low signal circuit for a short to the HO2S 1 heater low control circuit. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 15 | Go to Step 10 |
| 8 | Test the HO2S 1 high signal circuit for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 15 | Go to Step 12 |
| 9 | Test the HO2S 1 high signal circuit for a short to the following circuits:
Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 15 | Go to Step 12 |
| 10 |
|
- | Go to Step 15 | Go to Step 11 |
| 11 | Test for shorted terminals and for poor connections at the HO2S 1. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 15 | Go to Step 13 |
| 12 | Test for shorted terminals and for poor connections at the powertrain control module (PCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 15 | Go to Step 14 |
| 13 |
NOTE:
Refer to Heated Oxygen Sensor (HO2S) Resistance Learn Reset Notice
in Cautions and Notices. Replace the HO2S 1. Refer to Heated Oxygen Sensor Replacement - Position 1
or Heated Oxygen Sensor Replacement - Position 2
.Did you complete the replacement? |
- | Go to Step 15 | - |
| 14 | Replace the PCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 15 | - |
| 15 |
|
- | Go to Step 2 | Go to Step 16 |
| 16 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |