LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2006 >> i-280 S, Standard >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System >> Repair Instructions >> Front Wheel Speed Sensor Replacement (4WD) >> Removal Procedure

Removal Procedure

CAUTION: Refer to BRAKE DUST CAUTION .
CAUTION: Refer to ABS COMPONENT HANDLING CAUTION .
    Fig 1: View Of Steering Knuckle
    GM1135803Courtesy of GENERAL MOTORS CORP.
  1. Remove the steering knuckle. Refer to STEERING KNUCKLE REPLACEMENT (2WD) or STEERING KNUCKLE REPLACEMENT (4WD)
  2. Fig 2: View Of Speed Sensor Bracket Front Retaining Bolt
    GM1253304Courtesy of GENERAL MOTORS CORP.
  3. Remove the wheel speed sensor harness bracket bolt from the steering knuckle.
  4. Fig 3: Identifying Wheel Speed Sensor Harness Mounting Bolts
    GM1791020Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note the orientation of the wheel speed sensor harness to the steering knuckle to ensure correct installation.
  5. Using white or bright colored paint, mark the location of the wheel speed sensor harness to the steering knuckle.
  6. Remove the wheel hub/bearing bolts (1).
  7. Remove the brake rotor (2) and the wheel hub/bearing as an assembly from the steering knuckle (3) while routing the wheel speed sensor harness through the steering knuckle.
  8. Fig 4: View Of Wheel Speed Sensor And Wheel Hub/Bearing Assembly
    GM1790694Courtesy of GENERAL MOTORS CORP.
  9. Using white or bright colored paint, mark the location of the wheel speed sensor harness to the wheel hub/bearing assembly.
  10. IMPORTANT: DO NOT lever or pry against the wheel speed sensor tone wheel under the wheel speed sensor. Lever against the wheel hub ONLY.
  11. Using a suitable tool, pry or lever the wheel speed sensor off of the wheel hub/bearing housing.

    Discard the wheel speed sensor.