LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2004 >> Axiom Base, 4WD >> Repair and Diagnosis >> Steering >> Power Steering >> Power-Assisted Steering System >> Front End Alignment Inspection and Adjustment >> Trim Height Adjustment >> Caster Adjustment

Caster Adjustment

The caster angle can be adjusted by means of the caster shims (1) installed between the chassis frame (2) and fulcrum pins.

Caster angle:  2°30' +/- 1°

CAUTION: Left and right side must be equal within 30'.
Fig 1: Adjusting Caster (1 Of 2)
G02787244Courtesy of ISUZU MOTOR CO.
Fig 2: Adjusting Caster (2 Of 2)
G02787245Courtesy of ISUZU MOTOR CO.
NOTE: Difference of the caster shim front/rear thickness should be 3.6 mm (0.142 in) or less. Overall thickness of caster shim and camber shim should be 10.8 mm (0.425 in) or less.

Tighten the fulcrum pin bolt to the specified torque.

Torque:  152 N.m 112 (lb ft)