Control Assembly: Service and Repair

CONTROL LEVER ASSEMBLY AND/OR CABLES

REMOVAL

Control Lever Assembly And/Or Cables:

Preparation:
- Battery ground cable.

1. Glovebox
2. Knobs




3. Heater bezel




4. Attaching screws
- Remove the 3 attaching screws and disconnect the control cables at heater unit and blower assembly.




5. Fan control lever and/or A/C switch connector.
- Pull the fan control lever out and disconnect the connectors.
6. Control lever assembly.




7. Clip
8. Control cables

INSTALLATION
- To install, follow the removal steps in the reverse order, noting the following point:




1. Adjust the control cables.

^ AIR SOURCE CONTROL CABLE
1. Slide the control lever to the left.
2. Connect the control cable at the "CIRC" position and fix it with the clip.

^ TEMPERATURE CONTROL CABLE
1. Slide the control lever to the left.
2. Connect the control cable at the "COLD" position and fix it with the clip.

^ AIR SELECT CONTROL CABLE
1. Slide the control lever to the right.
2. Connect the control cable at the "DEFROST" position and fix it with the clip.
- Check operation.