Work Procedure
- VEHICLE CONDITION CHECK
-
- Park the vehicle in the straight-forward position.
- Unload the vehicle (no passenger aboard).
>>
GO TO 2.
-
- SENSOR INITIALIZE
CONSULT
- Ignition switch ON.
- Select "SENSOR INITIALIZE" in "Work support" mode of "IPDM E/R".
- Touch "Start".
- When "INITIALIZE COMPLETE", touch "End".NOTE:
If "INITIALIZE NOT DONE" is indicated, IPDM E/R detects that the front/rear height sensor signal changes and sensor initialize is cancelled. In this case, place the ignition switch to OFF to prevent the vehicle from height change and perform sensor initialize again.
Is the sensor initialize completed?
YES>>
GO TO 3.
NO>>
Perform the sensor initialize again.
- SELF DIAGNOSTIC RESULT CHECK
CONSULT
- Select "Self Diagnostic Result" mode of "IPDM E/R".
- Check DTC.
Is DTC detected?
YES>>
GO TO 2.
NO>>
Work End.