System Description
SYSTEM DIAGRAM
| Component | Description |
|---|---|
| TCM | TCM |
| BCM | System Description |
| ABS actuator and electric unit (control unit) | ABS Actuator and Electric Unit (Control Unit) |
| Combination meter (FULL TFT METER) | Combination Meter |
| Combination meter (7 INCH INFORMATION DISPLAY) | Combination Meter |
| Side radar LH/RH | Side Radar LH/RH |
| BSW indicator LH, RH | BSW Indicator LH/RH |
SIDE RADAR INPUT/OUTPUT SIGNAL ITEM
Input Signal Item
| Transmit unit | Signal name | Description | |
|---|---|---|---|
| TCM | CAN communication | Shift position signal | Receives a select lever position |
| ABS actuator and electric unit (control unit) | CAN communication | Vehicle speed signal (ABS) | Receives wheel speeds of four wheels |
| BCM | CAN communication | Turn indicator signal | Receives an operational state of the turn signal lamp and the hazard lamp |
| Dimmer signal | Receives ON/OFF state of dimmer signal | ||
| Combination meter | CAN communication | System selection signal | Receives a selection state of each item selected with the information display |
Output Signal Item
| Reception unit | Signal name | Description | |
|---|---|---|---|
| Combination meter | CAN communication | Meter display signal | Transmits a signal to display a state of the system on the information display |
| Buzzer output signal | Transmits a signal to activate buzzer | ||
| BSW indicator LH, RH | BSW indicator signal | Transmits a BSW indicator signal to turn ON the BSW indicator | |
| BSW indicator dimmer signal | Transmits a BSW indicator dimmer signal to dimmer BSW indicator | ||
FUNCTION DESCRIPTION
- The Blind Spot Warning (BSW) system can help alert the driver of other vehicles in adjacent lanes when changing lanes.
- The BSW system uses side radar installed near the rear bumper to detect vehicles in an adjacent lane.
- The side radar can detect vehicles on either side of vehicle within the detection zone shown as illustrated.
- This detection zone starts from the outside mirror of vehicle and extends approximately 10 ft (3.0 m) behind the rear bumper, and approximately 10 ft (3.0 m) sideways.
- The BSW system operates above approximately 32 km/h (20 MPH).
- If the side radar detects vehicles in the detection zone, the BSW indicator illuminates.
- If the driver then activates the turn signal, a buzzer sounds twice and the BSW indicator blinks.NOTE:
A buzzer sounds if the side radar have already detected vehicles when the driver activates the turn signal. If a vehicle comes into the detection zone after the driver activates the turn signal, then only the BSW indicator blinks and no buzzer sounds.
OPERATION DESCRIPTION
- Side radar enables BSW system.
- The side radar turns on the BSW system when the turned ON by information display.
- Side radar detects a vehicle in the adjacent lane.
- Side radar starts the control as follows, based on a vehicle detection signal, turn signal and dimmer signal transmitted from BCM via CAN communication:
- Transmits BSW indicator signal and BSW indicator dimmer signal to BSW indicator.
- Transmits a buzzer output signal to combination meter.
OPERATION CONDITION
Side radar performs the control when the following conditions are satisfied.
- BSW system: ON
- Vehicle speed: Approximately 32 km/h (20 MPH) or more
NOTE:

- ON/OFF of BSW system is performed with the information display.
- After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 29 km/h (18 MPH)
- The BSW system may not function properly, depending on the situation. Refer to Handling Precaution .
CANCEL CONDITION
The side radar cancels the operation when the system is under any conditions of the operation cancellation condition.
- When the system malfunction occurs.
- When the area around the side radar is dirty.