LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2023 >> QX60 Autograph, FWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Removal And Installation >> Generator >> Removal and Installation

Removal and Installation

REMOVAL 

  1. Disconnect the battery negative terminal. Refer to Battery Disconnect .
  2. Remove compressor. Refer to Removal and Installation .
  3. Remove the drive belt auto-tensioner. Refer to Removal and Installation .
  4. Remove the front over fender. Refer to Removal and Installation .
  5. Partially remove the fender protector (front half). Refer to Exploded View .
  6. Remove "B" terminal nut and disconnect "B" terminal harness.
  7. Disconnect the harness connector from generator.
  8. Using a suitable jack (A), support the front suspension member and remove the two front bolts for the front suspension member. Refer to Exploded View .
    GNSDB45433Courtesy of NISSAN
  9. Lower the front suspension member.
    NOTE: SYMBOL The front suspension member should only be lowered enough to allow the generator to be removed [approximately 38 mm (1.5 in) ].
  10. Remove the generator bolts and remove the generator through the passenger wheel opening.

INSTALLATION 

Installation is in the reverse order of removal.

CAUTION:

Be sure to tighten "B" terminal nut carefully.